Belt Sander
Machine Overview:
The JSG-96 Benchtop Disc/Belt Sander is a versatile tool for shaping, smoothing, and finishing wood. It is a twofold machine, combining a 9-inch disc sander and a 5.8750 x 48-inch belt sander, making it ideal for sanding edges, rounding corners, or smoothing surfaces. Its adjustable belt and disc tables can handle both flat and angled sanding jobs.
Safety Prerequisites:
Ensure the following when using the belt sander:
Personal Safety:
You are wearing safety glasses
You are NOT wearing gloves or loose accessories
Environmental Safety:
Turn on ventilation before operation
Sweep up any excess sawdust after operation
Operational Safety:
An AMS mentor is in the wood room with you
Your piece is a suitable material for the belt sander (wood only).
Your piece has excessive material to hold onto and will not snap easily due to being thin or brittle
The machine is clear of excessive dust, and debris
How to Use:
*If using the belt sander, use the levers to the left and right of the belt table to match the angle you would like to sand into your part
*If using the disc sander, use the lever beneath the disc table to match the angle you would like to sand into your part
Check to make sure the machine is plugged in
Press the on button to start the machine
Lay your part on the table and slowly push into the machine, ensuring your fingers are at least 3" from the sanding belt or disc at all times
When your part is sanded down to the desired dimension, remove the part from the machine, and press the off button to stop the machine
Wait for the belt or disc to fully stop, and clean up any dust you created

OEM Manual:
JSG-96 Benchtop Disc/Belt Sander
Specifications:
Belt Table Tilt (Deg.):
10 Up, 45 Down
Belt Width (in.):
5.8750
Disc Diamter (in.):
9.0000
Motor AMPS:
11
Motor Power (HP):
3/4
Gross Weight (lbs):
100.0
Last updated
Was this helpful?